The FTIR measurement principle enables the simultaneous acquisition of more than 12 measuring components. The MCS100FT FTIR analyzer system with its heated measuring cell made of corrosion-resistant material also enables monitoring of hydrogen fluoride limits as required by legislation. With its reliable measurement technology, easy operation, and low maintenance requirements, the MCS100FT provides a hassle-free solution concept that offers unequaled opportunities.
Emission monitoring in waste incineration plants
Reliable HF limit value monitoring
Monitoring of gaseous emissions in cement or power plants
Device properties:
Small suitability-tested HF measuring range: 0 ... 3 mg/m³
Automatic spectrum adjustment via AutoVAL for reliable measured values
Suitability-tested according to EN15267
Remote control and diagnosis via SOPAS ET software
Automatic adjustment of the analyzer
Automatic backwashing and filter cleaning of the extraction unit
Fordeler
Reliable HF limit value monitoring
Just one analyzer for over 12 measuring components
Easy integration into the customer network environment
Long 6-month maintenance interval for many measuring components
Suitability-tested measurement of greenhouse gases such as N2O, CH4 and CO2
Discover how Ciments Calcia is transforming its French sites with low‑carbon innovation, next‑gen clinker production, and high‑performance gas analysis systems delivered with speed and reliability.
Learn how Raman Spectroscopy can provide analysis solutions for challenging stream conditions, by reading the white paper focused on two different customer case studies.
Borealis is monitoring of polypropylene and polyethylene grades during olefin polymerization reactions in continuously fed loop reactors in the Chemical Industry.
+5 °C ... +35 °C With cooling device:+5 °C ... +50 °C
Ambient humidity
≤ 80 % Non-condensing
Conformities
Approved for plants requiring approval: 2001/80/EC (13. BImSchV) 2000/76/EC (17. BImSchV) 27. BImSchV TA-Luft (Prevention of Air Pollution) EN 15267 EN 14181 MCERTS
Modulært system I/O –
Analoge og digitale grensesnittmoduler
Driftsinstruksjon (BA)
Norsk versjon - 01/2025
New version available in English
Modulært system-I/O brukes til inn- og utlesing av analoge og digitale signaler. Det kan brukes som enkeltkomponent eller til utvidelse av SCU (System Control Unit).
Fortsett for å velge blant alle mulige alternativer
Vi verdsetter personvernet ditt
Vi bruker informasjonskapsler til å forbedre surfeopplevelsen din, samle inn statistikk for å optimalisere nettstedsfunksjonalitet og vise skreddersydde annonser eller skreddersydd innhold.
